40485002
Used-Sandvik belt flaker, stainless steel chilled belt conveyor machine. Belt width is 94", conveyor bed length (distance between 12 o'clock positions on drive and idler pulleys) is 59'2". Overall frame width is 107-7/8", overall frame length is 67'6", conveyor belt distance above floor is 68-1/2". Drain piping, chiller and pumps are included. Chiller info: details
|
40485001
Used-Sandvik belt flaker, stainless steel chilled belt conveyor machine. Belt width is 94", conveyor bed length (distance between 12 o'clock positions on drive and idler pulleys) is 59'2". Overall frame width is 107-7/8", overall frame length is 67'6", conveyor belt distance above floor is 68-1/2". Drain piping, chiller and pumps are included. Chiller info: details
|
40155003
Used: Ecolab continuous pan washer, model CD-906PW, stainless steel. Approx 51" wide x 15' long wash/dry area, 40" long infeed, 40" long outfeed table. Will wash 18" wide x 38" long x 2-1/2" deep pans at 5 per minute. System includes a chain conveyor, wash section, mid and final rinse section, and drying section, misc holding tanks, pumps, blower and details
|
REQUEST PRICE QUOTE
Width (in.): 64
Length (in.): 96
Material:
Manufacturer: Infra-red Technologi
523175
USED: Infra-red Technologies belt dryer. 170 cfm with 1/15 hp exhaustfan. Recirculation fans Convection 3600 cfm with 3 hp motor 150 BCPL,Infrared 1000 cfm with 1 hp motor, total BTU Infrared 144,000,Convection 400,000. Electric supply 488V/3 ph/60 hz and 120V/1 ph/60 hz. Heat model Infrared (3) B24x48CNBF, Convection APX5. 5'4" highx 7' wide x 8' long details
|
|
|
REQUEST PRICE QUOTE
Width (in.): 12
Length (in.): 144
Material: stainless steel
Manufacturer: Sandvik
522928
USED: Sandvik belt flaker complete with temperature controls andcomplete control panel with variable speed drive. Belt is 12" wide x12' in length. Belt is stainless steel and is complete with Johnsonrotary joints. Controls built by Zesta Engineering Ltd. Model ZCP234is designed for 480 volt, 3 phase, 60 hz. Overall dimensions: 36" widex 36" high x 14'6" details
|
|
|
|
|
|
|
REQUEST PRICE QUOTE
Width (in.): 12
Length (in.): 63
Material: 316 stainless steel
Manufacturer: Sandvik
84081
USED: Sandvik belt cooler, 316 stainless steel. 12" wide x 63" long belt, on 24" diameter cored rolls, driven by a 1/2 hp, 3/60/208-230/460 volt, 1725 rpm gearmotor, ratio 165:1. (2) Pneumatically adjustable top 8" diameter x 11-1/2" face cored applicator rolls, driven by a 1/2 hp, 3/60/208-230/460 volt, 1725 rpm gearmotor, ratio 165:1. End bottom discharge details
|
|
|
|
|
523427
USED: Aeroglide horizontal dryer model C2 84-58 RGX. Capacity 28,000 lbs/hour output @ 20% moisture in and 9% moisture out. (12,700 kg/hour output @ 20% moisture in and 9% moisture out.) Four zone, two pass drying deck of chain and perforated tray, 84" wide dryer bed, nominal length of dryer 60', nominal width 12'. Includes Aeroglide horizontal cooler details
|
520680
USED: Aeroglide horizontal dryer model C2 84-58 RGX. Capacity 28,000 lbs/hour output @ 20% moisture in and 9% moisture out. (12,700 kg/hour output @ 20% moisture in and 9% moisture out.) Four zone, two pass drying deck of chain and perforated tray, 84" wide dryer bed, nominal length of dryer 60', nominal width 12'. Includes Aeroglide horizontal cooler details
|
|
|
REQUEST PRICE QUOTE
Width (in.): 48
Length (in.): 96
Material:
Manufacturer: Proctor & Schwartz
77404
NEW/UNUSED: Proctor & Schwart cotton liner dryer system. Capacity:3000 lbs/hr. Moisture content entering dryer, max 10%, average 7% SDB.Moisture content leaving dryer 0.4%-1.0% SDB. Calculated temperaturein dryer 230 degrees F. Steam required at 90-100 PSIG approx 1100 lbs/hr. Total connected system HP=60. Dryer consists of linter balefeeding table, approximately details
|
|
|
|
|
REQUEST PRICE QUOTE
Width (in.): 70
Length (in.): 216
Material: Carbon Steel
Manufacturer: National Drying Mach
47936
USED: National Drying Machinery CS apron conveyor dryer cooler, typeAN3. Approx 100 sq ft, 5'10" x 18' CS perforated apron type belt,driven by 3/4 hp varispeed drive. Unit is gas fired by EclipseNo 240AH burner with 1/3 hp, 1/60/110 volt motor. Mas gas use 2500CFH @ 18" water column. Capacity 2,400,000 btu/hr. 7.5 hp, 3/60/220/440 volt. 36" dia axial flow details
|
|
|