|
|
|
|
|
|
40733017
Used-Rheometrics model RSA-2, solid material mechanical analyzer system. 15 amp, 220 volt. Actuator max force of 1000 G. Measurement sensitivity of 1 gm. Includes a control computer, environmental controller, an LN2 panel, and a Wilkerson model A00-AH-55 refrigerated dryer. Rated at 39 degrees F PDP @ 10 SCFM and 50 degrees F PDP @ 14 SCFM. details
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
40544015
Used- Premelters Inc hot melt, 304 stainless steel. 16'' X 16'' X approximately 24'' deep chamber with (4) heating zones, approximately 1 1/2'' center bottom outlet with a 1 hp, 180 volt, 1725 rpm DC motor discharge pump. Aluminium side panels, mounted on casters. Designed for polyurethane reactive (PUR) hot melts. Mounted on a cart with casters. details
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
40108009
Used:Ledco Inc. Signmaster 44'' hot roll laminator/ mounter. Maximum laminating width 44'', variable speed 1-25 feet per minute, laminating roll diameter 3'', roll core size 3'', film thickness 1 mil and up to 10 mil, maximum laminating thickness 1/2''. Driven by a 1/4hp,90 volt, DC gearmotor, ratio 58 to 1, with speed controller. 1500 watts,110 volt, details
|
|
|
|
|
|
|
|
|
89548
USED: DTM Sinterstation, model SLS2000. The DTM Sinterstation builds three dimensional products on a layer by layer fashion. The source material is mostly a plastic powder material (e.g. polyamide, polycarbonate). During the SLS process (selective laser sintering), the powder particles are selectively melted together by means of a laser beam. The laser energy details
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|